STARTER > INSPECTION |
| 1. INSPECT STARTER ARMATURE ASSEMBLY |
![]() |
Check the resistance.
Using an ohmmeter, check the resistance between the segments of the commutator.
![]() |
Check the resistance.
Using an ohmmeter, check the resistance between the commutator and armature coil core.
Check the commutator surface for dirt and burn.
If the surface is dirty or burnt, smooth the surface with 400- grit sandpaper or a lathe.
![]() |
Check the commutator diameter.
Using vernier calipers, measure the commutator diameter.
![]() |
Check the undercut depth.
Check that the undercut portion between the segments is free of foreign objects and measure its depth.
| 2. INSPECT STARTER YOKE ASSEMBLY |
![]() |
Check the resistance.
Using an ohmmeter, check the resistance between the lead wire and brushes.
![]() |
Check the resistance.
Using an ohmmeter, check the resistance between shunt coil terminals (A) and (B).
| 3. INSPECT BRUSH |
![]() |
Check the brush length.
Using vernier calipers, measure the brush length
| 4. INSPECT STARTER BRUSH HOLDER ASSEMBLY |
![]() |
Check the resistance.
Using an ohmmeter, measure the resistance between the positive (+) and negative (-) brush holders.
![]() |
Check the brush spring load.
Check the pull scale reading as soon as the brush spring is separated from the brush.
| 5. INSPECT STARTER CLUTCH SUB-ASSEMBLY |
![]() |
Check the operation.
Turn the clutch pinion gear clockwise and check that it turns freely. Try to rotate the clutch pinion gear counterclockwise and check that it locks.
If necessary, replace the starter clutch.
| 6. INSPECT MAGNET STARTER SWITCH ASSEMBLY |
![]() |
Check the resistance.
Using an ohmmeter, measure the resistance between terminals 50 and C.
![]() |
Check the resistance.
Using an ohmmeter, measure the resistance between terminal 50 and the switch body.