Home › ENGINE ยท 1GR-FE › STARTING › STARTER (for 2WD and Pre-Runner)

STARTER (for 2WD and Pre-Runner) > DISASSEMBLY

for Preparation Click here



1. REMOVE STARTER YOKE ASSEMBLY


A074096E02
  1. Remove the nut, then disconnect the lead wire from terminal C.

  1. Remove the 2 through bolts.

  1. Pull the starter yoke and the armature out together.

  1. Remove the O-ring from the starter yoke.



2. REMOVE MAGNET STARTER SWITCH ASSEMBLY


A074097E01
  1. Remove the 2 screws, then remove the magnet starter switch.



    A062427E01
  1. Remove these parts from the starter drive housing.
    (1)
    Starter magnet switch return spring
    (2)
    Starter idle gear pinion
    (3)
    Starter idle gear clutch roller
    (4)
    Starter idle gear retainer
    (5)
    Starter clutch



    ST00948E01
  1. Using a magnetic finger, remove the steel ball from the clutch shaft hole.



3. REMOVE STARTER BRUSH HOLDER ASSEMBLY


A062428E01
  1. Remove the 2 screws, then remove the end frame from the starter yoke.

  1. Remove the O-ring from the starter yoke.



    A062429E02
  1. Using a screwdriver, hold the spring back and disconnect the 4 brushes from the brush holder.

  1. Remove the brush holder from the armature.



4. REMOVE STARTER ARMATURE ASSEMBLY