STARTER (for 2WD and Pre-Runner) > REASSEMBLY |
| 1. INSTALL STARTER ARMATURE ASSEMBLY |
Apply grease to the bearings, and install it onto the starter yoke.
| 2. INSTALL STARTER BRUSH HOLDER ASSEMBLY |
Place the brush holder on the armature.
![]() |
Using a screwdriver, install the 4 brushes.
Install a new O-ring onto the groove of the field frame.
![]() |
Install the end frame with the 2 screws.
| 3. INSTALL MAGNET STARTER SWITCH ASSEMBLY |
Apply grease to the steel ball, and install it onto the clutch shaft hole.
![]() |
Apply grease to parts (2) - (5), and install all the parts below onto the starter drive housing.
| (1) | Starter magnet switch return spring |
| (2) | Starter idle gear pinion |
| (3) | Starter idle gear clutch roller |
| (4) | Starter idle gear retainer |
| (5) | Starter clutch |
![]() |
Install the magnet starter switch with the 2 screws.
| 4. INSTALL STARTER YOKE ASSEMBLY |
Install a new O-ring onto the groove of the starter yoke.
![]() |
Align the key of the starter yoke with the groove of the magnet starter switch.
![]() |
Install the starter yoke and armature with the 2 through bolts.
Connect the lead wire to terminal C with the nut.