STARTER (for 4WD) > DISASSEMBLY |
| 1. REMOVE STARTER YOKE ASSEMBLY |
![]() |
Remove the nut, then disconnect the lead wire from terminal C.
Remove the 2 through bolts.
Pull the starter yoke and the armature out together.
Remove the O-ring from the starter yoke.
| 2. REMOVE MAGNET STARTER SWITCH ASSEMBLY |
![]() |
Remove the 2 screws, then remove the magnet starter switch.
![]() |
Remove these parts from the starter drive housing.
| (1) | Starter magnet switch return spring |
| (2) | Starter idle gear pinion |
| (3) | Starter idle gear clutch roller |
| (4) | Starter idle gear retainer |
| (5) | Starter clutch |
![]() |
Using a magnetic finger, remove the steel ball from the clutch shaft hole.
| 3. REMOVE STARTER BRUSH HOLDER ASSEMBLY |
![]() |
Remove the 2 screws, then remove the end frame from the starter yoke.
Remove the O-ring from the starter yoke.
![]() |
Using a screwdriver, hold the spring back and disconnect the 4 brushes from the brush holder.
Remove the brush holder from the armature.
| 4. REMOVE STARTER ARMATURE ASSEMBLY |