Home › STEERING › POWER STEERING › POWER STEERING LINK (for 2WD)

POWER STEERING LINK (for 2WD) > INSPECTION

for Preparation Click here



1. INSPECT TIE ROD END SUB-ASSEMBLY


ZK08184
  1. Flip the ball joint stud back and forth 5 times as shown in the illustration before installing the nut.

  1. Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per turn and check the torque reading on the 5th turn.

    Torque:
    0.83 to 3.43 N*m{ 8.5 to 35.0 kgf*cm , 7.35 to 30.36 in.*lbf }



2. INSPECT POWER STEERING RACK


ZX09355
  1. Using a dial indicator, check the power steering rack for runout, teeth wear and damage.

    Maximum runout:
    0.3 mm (0.012 in.)

    If necessary, replace the power steering link assembly.

  1. Check the back surface for wear and damage.
    If necessary, replace the power steering link assembly.