Home › STEERING › POWER STEERING › POWER STEERING LINK (for 4WD and Pre-Runner)

POWER STEERING LINK (for 4WD and Pre-Runner) > INSPECTION

for Preparation Click here



1. INSPECT TIE ROD END SUB-ASSEMBLY


ZK08184E01
  1. Flip the ball joint stud back and forth 5 times as shown in the illustration before installing the nut.

  1. Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per turn and check the torque reading on the 5th turn.

    Torque:
    0.49 to 3.43 N*m{ 5.0 to 35.0 kgf*cm , 4.34 to 30.36 in.*lbf }



2. INSPECT POWER STEERING RACK


ZX09355E03
  1. Using a dial indicator, check the power steering rack for runout, teeth wear and damage.

    Maximum runout:
    0.3 mm (0.012 in.)

    If necessary, replace the power steering link assembly.

  1. Check the back surface for wear and damage.
    If necessary, replace the power steering link assembly.