Home › ENGINE ยท 2TR-FE › CHARGING › GENERATOR

GENERATOR > DISASSEMBLY

for Preparation Click here



1. REMOVE GENERATOR PULLEY


A075664E04
SST
09820-63010   (09820-06010, 09820-06020)

HINT:
SST 1-A and B
09820-06010
SST 2
09820-06020

  1. Hold SST 1-A with a torque wrench, and tighten SST 1-B clockwise with the specified torque.

    Torque:
    39 N*m{ 400 kgf*cm , 29 ft.*lbf }

    NOTICE:
    Check that the SST is secured to the generator rotor shaft.



    A075665E03
  1. Mount SST 2 in a vise.

  1. Insert SST 1-A and B into SST 2, and attach the generator pulley nut to SST 2.



    A075666E02
  1. To loosen the generator pulley nut, turn SST 1-A in the direction shown in the illustration.

    NOTICE:
    To prevent damage to the rotor shaft, do not loosen the generator pulley nut more than one-half turn.

  1. Remove the generator from SST 2.



    A075667E04
  1. Turn SST 1-B, and remove SST 1-A and B.

  1. Remove the generator pulley nut and generator pulley.



2. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY


A075669E01
  1. Remove the nut and terminal insulator.

  1. Remove the nut, screw and rectifier plate.

  1. Remove the 2 nuts and rear end cover.



    G037888E01
  1. Remove the brush cover from the generator brush holder assembly.

  1. Remove the 3 screws and generator brush holder assembly.

  1. Remove the plate seal.



3. REMOVE GENERATOR REGULATOR ASSEMBLY


G037883E01
  1. Remove the 2 screws and generator regulator assembly.



4. REMOVE GENERATOR HOLDER WITH RECTIFIER


G037884E01
  1. Remove the 3 screws and generator rectifier holder.



5. REMOVE GENERATOR ROTOR ASSEMBLY


G037885E01
  1. Remove the 3 terminal insulators from the rectifier end frame.

  1. Remove the 4 nuts.



    G037886E01
  1. Using SST, remove the rectifier end frame.

    SST
    09286-46011  

  1. Remove the plate retainer.

  1. Remove the generator rotor assembly from the drive end frame.

    NOTICE:
    Do not drop the generator rotor assembly.

    HINT:
    If the generator rotor is engaged too firmly, lightly tap the generator rotor shaft to remove it using a plastic hammer.