GENERATOR (for DENSO Made) > INSPECTION |
| 1. INSPECT GENERATOR BRUSH HOLDER ASSEMBLY |
![]() |
Using vernier calipers, measure the exposed brush length.
| 2. INSPECT GENERATOR ROTOR ASSEMBLY |
![]() |
Check the rotor for an open circuit.
Using an ohmmeter, measure the resistance between the slip rings.
![]() |
Check the rotor for ground.
Using an ohmmeter, measure the resistance between the slip ring and rotor.
Inspect the slip rings.
Check that the slip rings are not rough or scored. If rough or scored, replace the rotor.
![]() |
Using vernier calipers, measure the slip ring diameter.
| 3. INSPECT GENERATOR ROTOR BEARING |
![]() |
Check the bearing whether it is rough or worn. If necessary, replace the generator rotor.