Home › ENGINE ยท 1GR-FE › CHARGING › GENERATOR (for DENSO Made)

GENERATOR (for DENSO Made) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE V-BANK COVER


A075593E01
  1. Remove the 2 nuts, then remove the V-bank cover.



3. REMOVE RADIATOR SUPPORT TO FRAME SEAL LH


G036137E02
  1. Disengage the 9 clips, then remove the radiator support to frame seal.



4. REMOVE FAN SHROUD


G036138E01
  1. Disconnect the hose from the radiator reserve tank.



    G036139E01
  1. Remove the 2 cooler hoses from the clamp (with automatic transmission).

  1. Remove the 4 nuts from the fan pulley.

  1. Remove the fan and generator V belt .

  1. Remove the 2 bolts from the fan shroud.

  1. Remove the fan pulley and fan shroud.



5. REMOVE GENERATOR ASSEMBLY


A076407E01
  1. Disconnect the wire harness.

    1. Remove the bolt and wire harness stay.

    2. Disconnect the connector from the generator assembly.

    3. Remove the terminal cap and nut.

    4. Disconnect the wire harness from terminal B.



    A076408E01
  1. Remove the 2 bolts, then separate the wire harness clamp bracket from the generator assembly.



    A076409E01
  1. Remove the 2 bolts, then remove the generator assembly.