GENERATOR (for DENSO Made) > DISASSEMBLY |
| 1. REMOVE GENERATOR PULLEY |
![]() |
| SST 1-A and B | 09820-06010 |
| SST 2 | 09820-06020 |
Hold SST 1-A with a torque wrench, and tighten SST 1-B clockwise to the specified torque.
![]() |
Mount SST 2 in a vise.
Insert SST 1-A and B into SST 2, and attach the pulley nut to SST 2.
![]() |
To loosen the pulley nut, turn SST 1-A in the direction shown in the illustration.
Remove the generator from SST 2.
![]() |
Turn SST 1-B, and remove SST 1-A and B.
Remove the pulley nut and pulley.
| 2. REMOVE REAR GENERATOR END COVER |
![]() |
Place the generator on the pulley.
Remove the 3 nuts, then remove the rear end cover.
| 3. REMOVE TERMINAL INSULATOR |
![]() |
| 4. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY |
![]() |
Remove the plate seal.
Remove the 2 nuts, then remove the brush holder.
Remove the plate seal.
| 5. REMOVE GENERATOR COIL ASSEMBLY |
![]() |
Remove the 4 bolts.
![]() |
Using SST, remove the coil.
| 6. REMOVE GENERATOR ROTOR ASSEMBLY |
![]() |
Remove the generator washer and the generator rotor.
| 7. REMOVE GENERATOR DRIVE END FRAME BEARING |
![]() |
Check the bearing whether it is rough or worn. If necessary, replace the bearing.
![]() |
Remove the 4 screws, then remove the retainer plate.
![]() |
Using SST, tap out the bearing.