GENERATOR (for DENSO Made) > REASSEMBLY |
| 1. INSTALL GENERATOR DRIVE END FRAME BEARING |
![]() |
Using SST and a press, press in a new bearing.
Install the retainer plate with the 4 screws.
| 2. INSTALL GENERATOR ROTOR ASSEMBLY |
Place the drive end frame on the rotor.
Install the rotor and washer.
| 3. INSTALL GENERATOR COIL ASSEMBLY |
![]() |
Using a deep socket wrench 21 and a press, in the generator rectifier end frame carefully.
![]() |
Install the 4 bolts.
| 4. INSTALL GENERATOR BRUSH HOLDER ASSEMBLY |
![]() |
While pushing the 2 brushes to inside the brush holder, insert a pin (φ1.0 mm (0.039 in.)) into the brush holder hole.
![]() |
Install the generator brush holder with the 2 screws.
Pull out the pin (φ1.0 mm (0.039 in.)) from the generator brush hold.
| 5. INSTALL TERMINAL INSULATOR |
![]() |
Install the terminal insulator to the generator rectifier end frame.
| 6. INSTALL REAR GENERATOR END COVER |
Install the rear end cover with the 3 nuts.
| 7. INSTALL GENERATOR PULLEY |
![]() |
| SST 1-A and B | 09820-06010 |
| SST 2 | 09820-06020 |
Install the pulley onto the rotor shaft by tightening the pulley nut by hand.
Hold SST 1-A with a torque wrench, and tighten SST 1-B clockwise to the specified torque.
![]() |
Mount SST 2 in a vise.
Insert SST 1-A and B into SST 2, and attach the pulley nut to SST 2.
![]() |
Tighten the pulley nut by turning SST 1-A in the direction shown in the illustration.
Remove the generator from SST 2.
![]() |
Turn SST 1-B, and remove SST 1-A and B.
Turn the pulley and check that the pulley moves smoothly.