Home › ENGINE ยท 1GR-FE › CHARGING › GENERATOR (for BOSCH Made)

GENERATOR (for BOSCH Made) > DISASSEMBLY

for Preparation Click here



1. REMOVE REAR GENERATOR END COVER


G036204E02
  1. Remove the 2 terminal covers by turning them counterclockwise.



    G036205E02
  1. Using a 15 mm socket wrench, remove the 2 nuts from the generator rear end cover.

  1. Remove the screw, then remove the generator rear end cover.



2. REMOVE REGULATOR SUB-ASSEMBLY GENERATOR W/BRUSH


G036206E01
  1. Remove the 3 screws, then remove the regulator generator with brush.



3. REMOVE STATOR SUB-ASSEMBLY GENERATOR W/RECTIFIER


G036207E01
  1. Remove the 4 screws.



    G036208E01
  1. Using a screwdriver, pry out the stator generator with rectifier.



4. REMOVE BEARING SET GENERATOR


G036209E01


5. REMOVE PULLEY SET GENERATOR
  1. Clamp the swivel arm in a vise.

    NOTICE:
    Do not clamp the generator rotor in a vise.



    G036210E01
  1. Using a socket 24 AF and 8 mm bi-hexagon wrench, remove the nut and spring washer, then detach the pulley.



6. REMOVE GENERATOR ROTOR ASSEMBLY


G036211E02
  1. Using a press, press out the generator rotor assembly and spacer ring.