Home › ENGINE ยท 1GR-FE › CHARGING › GENERATOR (for BOSCH Made)

GENERATOR (for BOSCH Made) > REASSEMBLY

for Preparation Click here



1. INSTALL GENERATOR ROTOR ASSEMBLY


G036211E01
  1. Using SST and a press, press in the generator rotor assembly.

    SST
    09285-76010  

    NOTICE:
    Avoid misalignment during pressing.



2. INSTALL PULLEY SET GENERATOR


G036212E01
  1. Install the spacer ring.



    G036210E01
  1. Using a socket 24 AF and 8 mm bi-hexagon wrench, install the pulley with the spring washer and nut.

    Torque:
    65 N*m{ 663 kgf*cm , 48 ft.*lbf }



3. INSTALL BEARING SET GENERATOR


G036209E01
  1. Align the 3 cutouts of the bearing set generator with the stator generator with rectifier.



4. INSTALL STATOR SUB-ASSEMBLY GENERATOR WITH RECTIFIER


G036207E01
  1. Align the key of the drive end frame with the keyway of the stator sub-assembly generator with rectifier.

  1. Install the stator generator with rectifier with the 4 bolts.

    Torque:
    4.3 N*m{ 44 kgf*cm , 38 in.*lbf }



5. INSTALL REGULATOR SUB-ASSEMBLY GENERATOR WITH BRUSH


A095770E01
  1. Attach the brushes and terminals to the rectifier end frame of the regulator generator with brush.



  1. Install the regulator generator with brush with the 3 screws.

    HINT:
    Install the screw B into the position shown in the illustration.



    G036213E01

    Torque:
    2.5 N*m{ 25 kgf*cm , 22 in.*lbf } for screw A
    1.2 N*m{ 12 kgf*cm , 11 in.*lbf } for screw B



6. INSTALL REAR GENERATOR END COVER


G036205E01
  1. Install the generator rear end cover with the 2 nuts and screw.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf } for nut A
    12 N*m{ 122 kgf*cm , 9 ft.*lbf } for nut B
    2.8 N*m{ 29 kgf*cm , 25 in.*lbf } for screw



    G036204E02
  1. Install the 2 terminal covers by turning them clockwise.