AUTOMATIC TRANSMISSION FLUID > ADJUSTMENT |
| 1. BEFORE FILLING TRANSMISSION |
| 2. TRANSMISSION PAN FILL |
![]() |
Remove the refill plug and overflow plug.
![]() |
Fill the transmission through the refill hole until fluid begins to trickle out of the overflow tube.
Reinstall the overflow plug.
| 3. TRANSMISSION FILL |
Fill the transmission with the correct amount of fluid as listed in the table below.
Reinstall the refill plug to avoid fluid splash.
| Repair | Fill Amount |
| Transmission pan and drain plug removal | 1.3 L (1.37 US qts, 1.14 lmp qts) |
| Transmission valve body removal | 3.9 L (4.12 US qts, 3.43 lmp qts) |
| Torque converter removal | 5.3 L (5.60 US qts, 4.66 lmp qts) |
| Entire transmission assembly | 5.3 L (5.60 US qts, 4.66 lmp qts) |
| 4. FLUID CIRCULATION |
Allow the engine to idle with the air conditioning OFF.
Move the shift lever through entire gear range to circulate fluid.
| 5. FLUID TEMPERATURE CHECK |
![]() |
With intelligent tester
Connect the intelligent tester to the DLC3.
Select the tester menus: OBD/MOBD, ENGINE, DATA LIST and A/T.
Check A/T OIL TEMP.
Allow the engine to idle until the fluid temperature reaches 46°C (115°F).
Without intelligent tester (Using A/T OIL TEMP indicator)
Connect terminals between CG (4) and TC (13) of the DLC3 using SST (09843-18040).
Move the shift lever back and forth between N and D every 1.5 seconds for six seconds.
The D shift indicator on the combination meter comes on for two seconds. This indicates that the fluid temperature check mode has been started.
The D shift indicator will come on again when the fluid temperature reaches 46°C (115°F) and will blink when it exceeds 56°C (130°F).
Allow the engine to idle until the fluid temperature reaches 46°C (115°F).
| 6. FLUID LEVEL CHECK |
![]() |
Remove the overflow plug with the engine idling.
Check that the fluid comes out of the overflow tube.
If fluid does not come out, proceed to step 7.
If fluid comes out, wait until the overflow slows to a trickle and proceed to step 8.
| 7. TRANSMISSION REFILL |
Install the overflow plug.
Stop the engine.
Remove the refill plug.
Add 0.4 liters (0.42 US qts, 0.35 lmp qts) of fluid.
Allow the engine to idle and wait for 10 seconds.
Proceed to step 6.
| 8. COMPLETE |
Install the overflow plug with a new gasket.
Stop the engine.
Install the refill plug with a new gasket.