Home › DRIVE LINE › DIFFERENTIAL › DIFFERENTIAL LOCK SYSTEM

DIFFERENTIAL LOCK SYSTEM > INSPECTION

for Preparation Click here



1. INSPECT CENTER DIFFERENTIAL LOCK SWITCH


F051298E01
  1. Check the resistance.

    1. Measure the resistance using an ohmmeter.

      Standard:
      Tester Connection
      Switch Condition
      Specified Condition
      3 - 4
      Released
      10 kΩ or higher
      3 - 4
      Pushed in
      Below 1 Ω

      If the result is not as specified, replace the center differential lock switch.



2. INSPECT NO. 1 TRANSFER INDICATOR SWITCH


F051400E01
  1. Check the resistance.

    1. Measure the resistance using an ohmmeter.

      Standard:
      Tester Connection
      Switch Condition
      Specified Condition
      1 - 2
      Released
      10 kΩ or higher
      1 - 2
      Pushed in
      Below 1 Ω

      If the result is not as specified, replace the No. 1 transfer indicator switch.