Home › BODY ELECTRICAL › LIGHTING › FRONT FOG LIGHT SWITCH

FRONT FOG LIGHT SWITCH > INSPECTION

for Preparation Click here



1. INSPECT FRONT FOG LIGHT SWITCH


E076076E02
  1. Check the resistance.

    1. Measure the resistance using an ohmmeter, and check the results in accordance with the value(s) in the table below.

      Standard:
      Tester Connection
      Condition
      Specified Condition
      1-2
      Illumination circuit
      Below 1 Ω
      3-4
      OFF
      10 kΩ or higher
      3-4
      ON
      Below 1 Ω

      If the result is not as specified, replace the front fog light switch assembly.

  1. Check the illumination operation.

    1. Connect the battery positive (+) lead to terminal 1 and the battery negative (-) lead to terminal 2, then check that the illumination comes on.

      Standard:
      Illumination comes on.

      If the illumination does not come on, replace the bulb.