Home › BODY ELECTRICAL › LIGHTING › MAP LIGHT ASSEMBLY

MAP LIGHT ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT MAP LIGHT ASSEMBLY


E076078E01
  1. Check the resistance.

    1. Measure the resistance using an ohmmeter, and check the results in accordance with the value(s) in the table below.

      Standard:
      Tester Connection
      Condition
      Specified Condition
      1-2
      OFF
      10 kΩ or higher
      1-2
      ON
      Below 1 Ω

      If the result is not as specified, replace the map light assembly.

  1. Check the light operation.

    1. Connect the battery positive (+) lead to terminal 1 and the battery positive (-) lead to terminal 2, then check that the light comes on.

      Standard:
      Light comes on.

      If the light does not come on, replace the bulb.