Home › ENGINE ยท 2TR-FE › COOLING › RADIATOR

RADIATOR > REASSEMBLY

for Preparation Click here



1. INSTALL RADIATOR TANK UPPER


G036195E01
  1. Install the new radiator tank.

  1. Tap the core plate with a soft-faced hammer until there is no gap between the core plate and radiator tank.



2. INSTALL RADIATOR TANK LOWER

HINT:
Perform the same procedures as for the radiator tank upper.



3. ASSEMBLE SST


A121955E01
SST
09230-01010   (09231-01010, 09231-01020)
  1. Install the punch assembly into the overhaul handle by inserting it into the hole in part A as shown in the illustration.

  1. While gripping the handle, adjust the stopper bolt so that dimension B is as shown in the illustration.

    Dimension B:
    8.4 mm (0.331 in.)



4. CAULK CORE PLATE


A122234E01
  1. Gently press SST against the core plate in the order shown in the illustration. After repeating this a few times, fully caulk the core plate by gripping the handle until stopped by the stopper bolt.

    SST
    09230-01010   (09231-01010, 09231-01020)

    HINT:
    Do not tap the portions indicated in the illustration or the oil cooler using SST. Use pliers or a similar tool. Be careful not to damage the core plate.



    G036194E01
  1. Check the core plate height (H) after completing the caulking.

    Plate height (H):
    8.7 to 9.1 mm (0.343 to 0.358 in.)

    If the height is not as specified, readjust the stopper bolt of the handle, then caulk it again.



5. INSTALL RADIATOR DRAIN COCK
  1. Install a new O-ring onto the drain cock plug.

  1. Install the drain cock plug.