CRANKSHAFT POSITION SENSOR > INSTALLATION |
| 1. INSTALL CRANKSHAFT POSITION SENSOR |
![]() |
Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.
![]() |
Install the camshaft position sensor with the bolt.
![]() |
Connect the crankshaft position sensor connector and the 2 wire harness clamps.
| 2. INSTALL IDLE PULLEY ASSEMBLY WITH BRACKET (W/ AIR CONDITIONING) |
![]() |
Using several steps, uniformly install and tighten the 5 bolts in the sequence shown in the illustration.
| 3. INSTALL COMPRESSOR AND MAGNETIC CLUTCH (W/ AIR CONDITIONING) |
![]() |
Install the compressor and magnetic clutch with the 4 bolts.
Connect the compressor and magnetic clutch connector.
![]() |
Install the bolt shown in the illustration.
| 4. INSTALL FAN AND GENERATOR V BELT (W/ AIR CONDITIONING) |
![]() |
Provisionally install the V belt onto each pulley.
Turn the hexagonal bolt on the V-ribbed belt tensioner clockwise and install the V belt onto the V-ribbed belt tensioner pulley.
| 5. INSTALL ENGINE UNDER COVER SUB-ASSEMBLY NO.1 (for 4WD and Pre-Runner) |
| 6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |