CRANKSHAFT POSITION SENSOR > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE ENGINE UNDER COVER SUB-ASSEMBLY NO.1 (for 4WD and Pre-Runner) |
| 3. REMOVE FAN AND GENERATOR V BELT (W/ AIR CONDITIONING) |
![]() |
Turning the hexagonal bolt on the V-ribbed belt tensioner clockwise, loosen and then remove the V belt.
| 4. SEPARATE COMPRESSOR AND MAGNETIC CLUTCH (W/ AIR CONDITIONING) |
![]() |
Remove the bolt shown in the illustration.
![]() |
Disconnect the compressor and magnetic clutch connector.
Remove the 4 bolts, then separate the compressor and magnetic clutch.
| 5. REMOVE IDLE PULLEY ASSEMBLY WITH BRACKET (W/ AIR CONDITIONING) |
![]() |
Remove the 5 bolts, then remove the idle pulley with bracket.
| 6. REMOVE CRANKSHAFT POSITION SENSOR |
![]() |
Disconnect the crankshaft position sensor connector and the 2 wire harness clamps.
![]() |
Remove the bolt, then remove the crankshaft position sensor.