Home › ENGINE ยท 2TR-FE › ENGINE MECHANICAL › DRIVE BELT

DRIVE BELT > INSTALLATION

for Preparation Click here



1. INSTALL FAN AND GENERATOR V BELT


G038204E01
  1. Provisionally install the V belt onto each pulley.

    NOTICE:
    Install the V belt onto each pulley and finally install the V belt onto the V-ribbed belt tensioner.

  1. Turn the hexagonal bolt on the V-ribbed belt tensioner clockwise and install the V belt onto the V-ribbed belt tensioner pulley.



2. INSPECT FAN AND GENERATOR V BELT


A095340E01
  1. Visually check the belt for excessive wear, frayed cords, etc..

    1. If any defects are found, replace the V-ribbed belt.
    2. Cracks on the rib side of the belt are considered acceptable. If the belt has chunks missing from the ribs, it should be replaced.



    A097753E02
  1. Check that the tensioner indicator mark is within range A shown in the illustration. If the mark is not within range A, replace the V belt.