ENGINE FRONT OIL SEAL > INSTALLATION |
| 1. INSTALL TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL |
![]() |
Apply a light coat of MP grease to the lip of a new oil seal.
Using SST, uniformly tap a new oil seal in until its surface is flush with the timing chain cover edge.
| 2. INSTALL CRANKSHAFT PULLEY |
![]() |
Align the set key of the crankshaft with the key groove of the pulley, and slide on the pulley.
Provisionally install a new crankshaft pulley bolt onto the crankshaft.
Using SST, hold the crankshaft pulley and tighten the crankshaft pulley bolt.
![]() |
Install the bracket with the bolt. (w/ AIR CONDITIONING)
| 3. INSTALL FAN SHROUD |
![]() |
Install the fan pulley.
![]() |
Install the fan shroud and fan with fluid coupling together.
Provisionally install the fan with fluid coupling with the 4 nuts.
![]() |
Install the 2 bolts shown in the illustration.
![]() |
Connect the oil cooler inlet and outlet hoses to the fan shroud. (for Automatic Transmission)
![]() |
Connect the radiator reserve tank hose to the radiator.
Install the fan generator V belt.
![]() |
Tighten the 4 nuts shown in the illustration.
| 4. INSTALL RADIATOR SUPPORT TO FRAME SEAL LH |
![]() |
Install the radiator support frame seal LH with the 9 clips.
| 5. ADD ENGINE COOLANT |
Tighten the engine drain plug.
Tighten the radiator drain plug.
Disconnect the 2 vinyl hoses.
Slowly fill the system with engine coolant.
Check the coolant level inside the radiator by squeezing the inlet and outlet radiator hoses several times by hand. If the coolant level goes down, add coolant.
Install the radiator cap securely.
Slowly pour coolant into the radiator reservoir until it reaches the FULL line.
Warm up the engine until the cooling fan operates.
| Item | Condition |
| Fan speed | Any setting except OFF |
| Temperature | Toward warm |
| Air condition switch | OFF |
Squeeze the inlet and outlet radiator hoses several times by hand while warning up the engine.
Stop the engine and wait until the coolant cools down.
Remove the radiator cap and check the coolant level inside the radiator.
If the coolant level is below the full level, perform the steps from (d) through (k) and repeat the operation until the coolant level remains at the full level.
Check the coolant level inside the radiator reservoir tank again. If it is below the full level, add coolant.
Install the engine under cover No. 1 with the 4 bolts. (PRE RUNNER AND 4WD TYPE)
| 6. CHECK FOR ENGINE COOLANT LEAKAGE |
![]() |
Fill the radiator with coolant and attach a radiator cap tester.
Warm up the engine.
Pump it up to 118 kPa (1.2 kgf/cm2, 17.1 psi) and check that the pressure does not drop.
| 7. CHECK FOR ENGINE OIL LEAKAGE |
| 8. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (for Pre Runner and 4WD Type) |
Install the No. 1 engine under cover with the 4 bolts.