ENGINE FRONT OIL SEAL > INSTALLATION |
| 1. INSTALL TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL |
![]() |
Apply MP grease to a new oil seal lip.
Using SST and a hammer, tap in the oil seal until its surface is flush with the timing chain cover edge.
| 2. INSTALL CRANKSHAFT PULLEY |
![]() |
Using SST, install the pulley set bolt.
| 3. INSTALL FAN SHROUD |
![]() |
Provisionally install the fan shroud together with the fan pulley.
Install the fan and generator V belt .
Install the fan pulley with the 4 nuts.
Install the fan shroud with the 2 bolts.
Install the 2 cooler hoses into the clamp (with automatic transmission).
Connect the hose to the radiator reserve tank.
| 4. INSTALL RADIATOR SUPPORT TO FRAME SEAL LH |
| 5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 6. CHECK FOR ENGINE OIL LEAKAGE |
| 7. INSTALL ENGINE UNDER COVER SUB-ASSEMBLY (for 4WD and Pre Runner Drive Type) |
Install the engine under cover with the 4 bolts.
| 8. INSTALL V-BANK COVER |
Install the V-bank cover with the 2 nuts.