ENGINE FRONT OIL SEAL > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE V-BANK COVER |
![]() |
Remove the 2 nuts, then remove the V-bank cover.
| 3. REMOVE RADIATOR SUPPORT TO FRAME SEAL LH |
![]() |
Disengage the 9 clips, then remove the radiator support to frame seal.
| 4. REMOVE NO.1 ENGINE UNDER COVER SUB-ASSEMBLY (for 4WD and Pre Runner Drive Type) |
Remove the 4 bolts and engine under cover.
| 5. REMOVE FAN SHROUD |
![]() |
Disconnect the hose from the radiator reserve tank.
![]() |
Remove the 2 cooler hoses from the clamp (with automatic transmission).
Remove the 4 nuts from the fan pulley.
Remove the fan and generator V belt .
Remove the 2 bolts from the fan shroud.
Remove the fan pulley and fan shroud.
| 6. REMOVE CRANKSHAFT PULLEY |
![]() |
Using SST, hold the crankshaft pulley and loosen the pulley set bolt.
![]() |
Using the pulley set bolt and SST, remove the crankshaft pulley.
| 7. REMOVE TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL |
![]() |
Using a screwdriver, pry out the oil seal.