Home
›
ENGINE ยท 2TR-FE
›
ENGINE MECHANICAL
›
CYLINDER HEAD
CYLINDER HEAD > INSPECTION
for Preparation
Click here
1. INSPECT CYLINDER HEAD SET BOLT
Using vernier calipers, measure the minimum diameter of the elongated thread at the measuring point.
Standard outside diameter:
10.76 to 10.97 mm (0.4236 to 0.4319 in.)
Minimum outside diameter:
10.40 mm (0.4094 in.)
HINT:
If a visual check reveals no excessively thin areas, check the center of the bolt (see illustration) and find the area that has the smallest diameter.