ENGINE UNIT > REPAIR |
| 1. REPAIR INTAKE VALVE SEAT |
![]() |
If the seating is too high on the valve face, use 30° and 45° cutters to correct the seat.
![]() |
If the seating is too low on the valve face, use 60° and 45° cutters to correct the seat.
Handrub the valve and valve seat with an abrasive compound.
Check the valve seating position.
| 2. REPAIR EXHAUST VALVE SEAT |
![]() |
If the seating is too high on the valve face, use 30° and 45° cutters to correct the seat.
![]() |
If the seating is too low on the valve face, use 60° and 45° cutters to correct the seat.
Handrub the valve and valve seat with an abrasive compound.
Check the valve seating position.