Home › ENGINE ยท 1GR-FE › ENGINE MECHANICAL › ENGINE ASSEMBLY

ENGINE ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT INTAKE MANIFOLD FOR WARPAGE


A076807E02
  1. Using a precision straight edge and feeler gauge, measure the warpage of the contact surfaces of the cylinder head and intake air surge tank.

    Maximum warpage:
    0.8 mm (0.031 in.) for Intake air surge tank side
    0.2 mm (0.008 in.) for Cylinder head side

    If warpage is greater than the maximum, replace the intake manifold.



2. INSPECT EXHAUST MANIFOLD FOR WARPAGE


A076808E01
  1. Using a precision straight edge and feeler gauge, measure the warpage of the top surface of the cylinder head.

    Maximum warpage:
    0.7 mm (0.028 in.)

    If warpage is greater than maximum, replace the exhaust manifold.

    HINT:
    Maximum warpage of each installation surface:
    0.3 mm (0.012 in.)