Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › SEAT POSITION SENSOR (for Bench Seat Type)

SEAT POSITION SENSOR (for Bench Seat Type) > REMOVAL

for Preparation Click here


NOTICE:
  1. If the wiring connector for the SRS is disconnected with the ignition switch in the ON position, DTCs will be recorded.
  2. Never use SRS parts from another vehicle. When replacing the parts, replace them with new ones.
  3. Never reuse a seat position sensor if an airbag has previously deployed in a collision.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.


2. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH


    B121777
  1. Slide the front seat to the most forward position.

  1. Disengage the hook.

  1. Disconnect the 2 connectors.

  1. Using a clip remover, remove the wiring harness clamp.

  1. Remove the wiring harness clamp.

  1. Remove the bolt and the front seat inner belt.



3. REMOVE FRONT SEAT INNER BELT ASSEMBLY RH


    B121778
  1. Slide the front seat to the most forward position.

  1. Disengage the hook.

  1. Disconnect the connector.

  1. Using a clip remover, remove the wiring harness clamp.

  1. Remove the wiring harness clamp.

  1. Remove the bolt and the front seat inner belt.



4. REMOVE FRONT SEAT HEADREST ASSEMBLY


    B121738E01
  1. Push in the 2 lock buttons of the 2 front seat headrest supports and remove the 2 front seat headrests.



5. REMOVE FRONT SEAT ASSEMBLY


    B121739
  1. Remove the belt of the front center seat outer belt from the front center seat outer belt guide.



    B121740
  1. Disconnect the 3 connectors.

  1. Using a clip remover, remove the 2 wiring harness clamps.



    B121741
  1. Remove the 4 bolts and the front seat.



6. REMOVE SEAT POSITION SENSOR PROTECTOR (for RHD)
  1. Remove the seat slide position sensor protector from the seat position airbag sensor.



7. REMOVE SEAT POSITION SENSOR (for RHD)


    C123159E01
  1. Disconnect the connector from the seat position sensor.

  1. Using "Torx" socket wrench T30, remove the "Torx" screw and the seat position sensor.



8. REMOVE SEAT POSITION SENSOR (for LHD)


    C123158E01
  1. Disconnect the connector from the seat position sensor.

  1. Using "Torx" socket wrench T30, remove the "Torx" screw and the seat position sensor.