Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Sound Signal Circuit between Radio Receiver and Stereo Component Amplifier

for Preparation Click here


DESCRIPTION

The radio receiver assembly sends sound signals to the stereo component amplifier assembly through this circuit.
Sound signals that have been sent are amplified by the stereo component amplifier assembly, and then sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly or speakers.

WIRING DIAGRAM


I045105E01

1.CHECK HARNESS AND CONNECTOR


    I101944E03
  1. Disconnect the R1 radio receiver assembly connector and S23 stereo component amplifier assembly connector.

  1. Check the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    L+ (S23-3) - L+ (R1-9)
    Below 1 Ω
    L- (S23-2) - L- (R1-19)
    Below 1 Ω
    R+ (S23-5) - R+ (R1-8)
    Below 1 Ω
    R- (S23-4) - R- (R1-18)
    Below 1 Ω
    L+ (S23-3) - Body ground
    10 kΩ or higher
    L- (S23-2) - Body ground
    10 kΩ or higher
    R+ (S23-5) - Body ground
    10 kΩ or higher
    R- (S23-4) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE