Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > TC and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

The DLC3 circuit enables reading of Diagnostic Trouble Codes (DTCs) with no intelligent testers by connecting terminals TC and CG of the DLC3 connector.
Stored DTCs are displayed in blinking patterns of the CRUISE MAIN indicator light located on the combination meter.

WIRING DIAGRAM


B125024E01

HINT:
When a particular warning light blinks continuously, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in the relevant ECU is suspected.

1.CHECK HARNESS AND CONNECTOR (TC of DLC3 - ECM)


    I101324E01
  1. Turn the ignition switch off.

  1. 1GR-FE:
    Disconnect the E8 connector of the ECM.

  1. 2TR-FE:
    Disconnect the E7 connector of the ECM.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance (1GR-FE):
    Tester connection
    Condition
    Specification
    TC (D4-13) - TC (E8-23)
    Always
    Below 1 Ω

    Standard Resistance (2TR-FE):
    Tester connection
    Condition
    Specification
    TC (D4-13) - TC (E7-17)
    Always
    Below 1 Ω

  1. Reconnect the ECM connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (TC of DLC3 - ECM)
OK


2.CHECK HARNESS AND CONNECTOR (TC of DLC3 - BODY GROUND)


    E107088E23
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester connection
    Condition
    Specification
    TC (D4-13) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (TC CIRCUIT)
OK


3.CHECK HARNESS AND CONNECTOR (CG of DLC3 - BODY GROUND)


    E107088E24
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester connection
    Condition
    Specification
    CG (D4-4) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (CG of DLC3 - BODY GROUND)
OK

REPLACE ECM