Home › ENGINE · 2TR-FE › ENGINE CONTROL SYSTEM › SFI SYSTEM

SFI SYSTEM > VC Output Circuit

for Preparation Click here


DESCRIPTION

The ECM constantly generates 5 V power from the battery voltage supplied to the +B (BATT) terminal to operate the microprocessor. The ECM also provides this power to the sensors through the VC output circuit.

A116143E04

When the VC circuit is short-circuited, the microprocessor in the ECM and sensors that are supplied power through the VC circuit are inactivated because the power is not supplied from the VC circuit. Under this condition, the system does not start up and the MIL does not illuminate even if the system malfunctions.

HINT:
Under normal conditions, the MIL is illuminated for several seconds when the ignition switch is first turned to ON. The MIL goes off when the engine is started.


WIRING DIAGRAM

Refer to the following pages.
  1. Throttle position sensor circuit .
  2. Canister pump module circuit .
  3. Secondary air injection pressure sensor circuit .
  4. Accelerator pedal circuit .

INSPECTION PROCEDURE

1.CHECK MIL
  1. Check that the Malfunction Indicator Lamp (MIL) lights up when turning the ignition switch ON.

    OK:
    MIL lights up



OK
SYSTEM OK
NG


2.CHECK CONNECTION BETWEEN INTELLIGENT TESTER AND ECM
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch ON and intelligent tester ON.

  1. Check the communication between the intelligent tester and ECM.
    Result
    Proceed to
    Communication is possible
    A
    Communication is not possible
    B



A
GO TO MIL CIRCUIT
B


3.CHECK MIL (THROTTLE BODY)
  1. Disconnect the throttle body connector.

  1. Turn the ignition switch ON.

  1. Check the MIL.

    Result:
    Result
    Proceed to
    MIL illuminates
    A
    MIL does not illuminate
    B



A
REPLACE THROTTLE BODY
B


4.CHECK MIL (ACCELERATOR PEDAL)
  1. Disconnect the accelerator pedal connector.

  1. Turn the ignition switch ON.

  1. Check the MIL.

    Result:
    Result
    Proceed to
    MIL illuminates
    A
    MIL does not illuminate
    B



A
REPLACE ACCELERATOR PEDAL ASSEMBLY
B


5.CHECK MIL (PRESSURE SENSOR FOR SECONDARY AIR INJECTION)
  1. Disconnect the pressure sensor connector.

  1. Turn the ignition switch ON.

  1. Check the MIL.

    Result:
    Result
    Proceed to
    MIL illuminates
    A
    MIL does not illuminate
    B



A
REPLACE PRESSURE SENSOR
B


6.CHECK MIL (CANISTER PUMP MODULE)
  1. Disconnect the canister pump module connector.

  1. Turn the ignition switch ON.

  1. Check the MIL.

    Result:
    Result
    Proceed to
    MIL illuminates
    A
    MIL does not illuminate
    B



A
REPLACE CHARCOAL CANISTER ASSEMBLY
B


7.CHECK HARNESS AND CONNECTOR
  1. Disconnect the throttle body connector.

  1. Disconnect the accelerator pedal connector.

  1. Disconnect the pressure sensor connector.

  1. Disconnect the canister pump module connector.



    A079127E02
  1. Disconnect the ECM connector.

  1. Measure the resistance of the wire harness side connector.

    Standard Resistance (check for short):
    Tester Connection
    Specified Condition
    VC (E4-18) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM