Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM

ANTI-LOCK BRAKE SYSTEM > TS and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

In sensor check mode, malfunctions of the speed sensor that cannot be detected when the vehicle is stopped are detected while driving.
Transition to the sensor check mode can be performed by connecting terminals TS and CG of the DLC3 and turning the ignition switch from OFF to the ON position.

WIRING DIAGRAM


C124749E02


INSPECTION PROCEDURE

1.INSPECT DLC3 TERMINAL VOLTAGE (TS TERMINAL)


    F100115E03
  1. Turn the ignition switch to the ON position.

  1. Measure the voltage.

    Standard Voltage:
    Tester Connection
    Specified Condition
    D4-12 (TS) - D4-4 (CG)
    10 to 14 V



NG
Go to step 3
OK


2.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - DLC3)


    C124792E01
  1. Disconnect the skid control ECU connector.

  1. Measure the resistance.

    Standard Resistance:
    Tester Connection
    Specified Condition
    S1-20 (TS) - D4-12 (TS)
    Below 1 Ω
    S1-20 (TS) - Body ground
    10 kΩ or higher

  1. Reconnect the skid control ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE BRAKE ACTUATOR 

3.CHECK HARNESS AND CONNECTOR (BODY GROUND - DLC3)


    F100115E04
  1. Measure the resistance.

    Standard Resistance:
    Tester Connection
    Specified Condition
    D4-4 (CG) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - DLC3)


    C124792E01
  1. Disconnect the skid control ECU connector.

  1. Measure the resistance.

    Standard Resistance:
    Tester Connection
    Specified Condition
    S1-20 (TS) - D4-12 (TS)
    Below 1 Ω
    S1-20 (TS) - Body ground
    10 kΩ or higher

  1. Reconnect the skid control ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE BRAKE ACTUATOR