Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
With the intelligent tester connected to the DLC3 and the ignition switch in the ON position, the ABS, TRAC and VSC data list can be displayed. Follow the prompts on the tester screen to access the DATA LIST.


Item
Measurement Item / Range (Display)
Normal Condition
Diagnostic Note
HB MOT RELAY
HB motor relay / ON or OFF
ON : Motor relay ON
OFF : Motor relay OFF
-
ABS MOT RELAY
ABS motor relay / ON or OFF
ON : Motor relay ON
OFF : Motor relay OFF
-
SOL RELAY
Solenoid relay / ON or OFF
ON : Solenoid relay ON
OFF : Solenoid relay OFF
-
VSC/TRAC OFF SW
TRAC control switch / ON or OFF
ON : TRAC control switch ON
-
IDLE SW
Main idle switch / ON or OFF
ON : Accelerator pedal released
OFF : Accelerator pedal depressed
-
STOP LIGHT SW
Stop lamp switch / ON or OFF
ON : Brake pedal depressed
OFF : Brake pedal released
-
PKB SW
Parking brake switch / ON or OFF
ON : Parking brake applied
OFF : Parking brake released
-
RESERVOIR SW
Reservoir level warning switch / ON or OFF
ON : Switch ON
OFF : Switch OFF
-
ABS OPERT FR
ABS operation (FR) / BEFORE or OPERATE
BEFORE : No ABS operation (FR)
OPERATE : During ABS operation (FR)
-
ABS OPERT FL
ABS operation (FL) / BEFORE or OPERATE
BEFORE : No ABS operation (FL)
OPERATE : During ABS operation (FL))
-
ABS OPERT RR
ABS operation (RR) / BEFORE or OPERATE
BEFORE : No ABS operation (RR)
OPERATE : During ABS operation (RR)
-
ABS OPERT RL
ABS operation (RL) / BEFORE or OPERATE
BEFORE : No ABS operation (RL)
OPERATE : During ABS operation (RL)
-
WHEEL SPD FR
Wheel speed sensor (FR) reading / min.: 0 MPH (0 km/h), max.: 202 MPH (326 km/h)
Actual wheel speed
Similar speed to that indicated on speedometer
WHEEL SPD FL
Wheel speed sensor (FL) reading / min.: 0 MPH (0 km/h), max.: 202 MPH (326 km/h)
Actual wheel speed
Similar speed to that indicated on speedometer
WHEEL SPD RR
Wheel speed sensor (RR) reading / min.: 0 MPH (0 km/h), max.: 202 MPH (326 km/h)
Actual wheel speed
Similar speed to that indicated on speedometer
WHEEL SPD RL
Wheel speed sensor (RL) reading / min.: 0 MPH (0 km/h), max.: 202 MPH (326 km/h)
Actual wheel speed
Similar speed to that indicated on speedometer
DECELERAT SEN
Deceleration sensor 1 reading / min.: -1.869 G, max.: 1.869 G
Approximately 0 +- 0.13G is still condition
Reading changes when vehicle bounced
DECELERAT SEN2
Deceleration sensor 2 reading / min.: -1.869 G, max.: 1.869 G
Approximately 0 +- 0.13G is still condition
Reading changes when vehicle bounced
IG VOLTAGE
ECU power supply voltage / TOO LOW / NORMAL / TOO HIGH
TOO HIGH: 14 V or more
NORMAL: 9.5 V or 14V
TOO LOW: Below 9.5 V
-
SFRR
ABS solenoid (SFRR) / ON or OFF
ON: Operates
OFF: Does not operate
-
SFRH
ABS solenoid (SFRH) / ON or OFF
ON: Operates
OFF: Does not operate
-
SFLR
ABS solenoid (SFLR) / ON or OFF
ON: Operates
OFF: Does not operate
-
SFLH
ABS solenoid (SFLH) / ON or OFF
ON: Operates
OFF: Does not operate
-
SRRR (SRR)
ABS solenoid (SRRR [SRR]) / ON or OFF
ON: Operates
OFF: Does not operate
-
SRRH (SRH)
ABS solenoid (SRRH [SRH]) / ON or OFF
ON: Operates
OFF: Does not operate
-
SRLR
ABS solenoid (SRLR) / ON or OFF
ON: Operates
OFF: Does not operate
-
SRLH
ABS solenoid (SRLH) / ON or OFF
ON: Operates
OFF: Does not operate
-
SRCF (SA1)
TRAC solenoid (SRCF [SMCF]) / ON or OFF
ON: Operates
OFF: Does not operate
-
SRCR (SA2)
TRAC solenoid (SRCR [SREA]) / ON or OFF
ON: Operates
OFF: Does not operate
-
SRMF (SMCF, SA3)
TRAC solenoid (SRMF [SREC]) / ON or OFF
ON: Operates
OFF: Does not operate
-
SRMR (SMCR, STR)
TRAC solenoid (SRMR [SMCR, STR]) / ON or OFF
ON: Operates
OFF: Does not operate
-
ENGINE SPD
Engine Speed/ Min.: 0 rpm, Max.: 6000 rpm
Actual engine speed
-
VEHICLE SPD
Maximum wheel speed sensor reading / min.: 0 MPH (0 km/h), max.: 202 MPH (326 km/h)
Actual engine speed
Speed indicated on speedometer
YAW RATE
Yaw rate sensor/ Min.: -128 deg/s, Max.: 127 deg/s
Min: -128 deg/s
Max: 127 deg/s
-
YAW ZERO VALUE
Memorized zero value/ Min.: -128 deg/s, Max.: 127 deg/s
Min: -128 deg/s
Max: 127 deg/s
-
STEERING ANG
Steering sensor/ Min.: -1152 deg, Max.: 1150.875 deg
Left turn: Increase
Right turn: Decrease
-
MAS CYL PRS 1
Master cylinder pressure sensor 1 reading / min.: 0V, max.: 5V
When brake pedal is released : 0.3 V to 0.9 V
Reading increases when brake pedal depressed
ACC PRESS SENS
Accumulator pressure sensor reading / min.: 0V, max.: 5V
min.: 3V
max.: 5V
If value constant regardless of pump operation, accumulator pressure sensor malfunction suspected.
WHEEL DIR FR
Front right wheel direction
wheel direction BACK: BACK, FORWARD: FORWARD
-
WHEEL DIR FL
Front left wheel direction
wheel direction BACK: BACK, FORWARD: FORWARD
-
WHEEL DIR RR
Rear right wheel direction
wheel direction BACK: BACK, FORWARD: FORWARD
-
WHEEL DIR RL
Rear left wheel direction
wheel direction BACK: BACK, FORWARD: FORWARD
-
SPD SEN FR
FR speed sensor open detection / OPEN or NORMAL
OPEN: momentary interruption
-
SPD SEN FL
FL speed sensor open detection / OPEN or NORMAL
OPEN: momentary interruption
-
SPD SEN RR
RR speed sensor open detection / OPEN or NORMAL
OPEN: momentary interruption
-
SPD SEN RL
RL speed sensor open detection / OPEN or NORMAL
OPEN: momentary interruption
-
ACCELERATOR %
Different % of present accelerator
min.: 0
max.: 128
-
TORQUE
Real output torque
min.: -1024
max.: 1016
-
TEST MODE
Test mode / Normal or TEST
NORMAL: Normal mode
TEST: During test mode
-
MAS CYL PRESS 1
Master cylinder pressure sensor 1 reading / min.: 0V, max.: 5V
When brake pedal released: 0.3 to 0.9V
Reading increases when brake pedal depressed
#CODES
Number of DTC recorded / min.: 0, max.: 255
min.: 0
max.: 255
-

ACTIVE TEST

HINT:
Performing the ACTIVE TEST using the intelligent tester allows relays and actuators to be operated without removing any parts. Performing the ACTIVE TEST as the first step of troubleshooting is one method of shortening diagnostic time.
It is possible to display the DATA LIST during the ACTIVE TEST.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to the ON position.

  3. Turn the tester ON.

  4. According to the display on the tester, perform the ACTIVE TEST.

    HINT:
    The ignition switch must be turned to the ON position to proceed to the Active Test using the intelligent tester.


Item
Vehicle Condition / Test Details
Diagnostic Note
SFRR
Turns ABS solenoid (SFRR) ON / OFF
Operation of solenoid (clicking sound) can be heard
SFRH
Turns ABS solenoid (SFRH) ON / OFF
Operation of solenoid (clicking sound) can be heard
SFLR
Turns ABS solenoid (SFLR) ON / OFF
Operation of solenoid (clicking sound) can be heard
SFLH
Turns ABS solenoid (SFLH) ON / OFF
Operation of solenoid (clicking sound) can be heard
SRRR
Turns ABS solenoid (SrRR) ON / OFF
Operation of solenoid (clicking sound) can be heard
SRRH
Turns ABS solenoid (SRRH) ON / OFF
Operation of solenoid (clicking sound) can be heard
SRLR
Turns ABS solenoid (SRLR) ON / OFF
Operation of solenoid (clicking sound) can be heard
SRLH
Turns ABS solenoid (SFLH) ON / OFF
Operation of solenoid (clicking sound) can be heard
SRCF (SA1)
Turns TRAC solenoid SRCF (SMCF) ON / OFF
Operation of solenoid (clicking sound) can be heard
SRCR (SA2)
Turns TRAC solenoid SRCR (SREA) ON / OFF
Operation of solenoid (clicking sound) can be heard
SRMF (SMCF, SA3)
Turns TRAC solenoid SRCR (SREA) ON / OFF
Operation of solenoid (clicking sound) can be heard
SRMR (SMCR, STR)
Turns TRAC solenoid SRMF (SMEC) ON / OFF
Operation of solenoid (clicking sound) can be heard
SFLR & SFLH
Turns ABS solenoid SFLR & SFLH ON / OFF
Operation of solenoid (clicking sound) can be heard
SRH & SRR
Turns ABS solenoid SRH & SRR ON / OFF
Operation of solenoid (clicking sound) can be heard
SRLR & SRLH
Turns ABS solenoid SRLR & SRLH ON / OFF
Operation of solenoid (clicking sound) can be heard
SFRH & SFLH
Turns ABS solenoid SFRH & SFLH ON / OFF
Operation of solenoid (clicking sound) can be heard
SRCF & SRCR
Turns ABS solenoid SRCF & SRCR ON / OFF
Operation of solenoid (clicking sound) can be heard
SRMF & SRMR
Turns ABS solenoid SRMF & SRMR ON / OFF
Operation of solenoid (clicking sound) can be heard
SOL RELAY
Turns ABS solenoid relay ON / OFF
Operation of solenoid (clicking sound) can be heard
ABS MOT RELAY
Turns ABS motor relay ON / OFF
Operation of motor can be heard
TRAC MOT RELAY
Turns TRAC motor relay ON / OFF
Operation of motor can be heard
ABS WARN LIGHT
Turns ABS warning light ON / OFF
Operation of motor can be heard
VSC WARN LIGHT
Turns VSC TRAC warning light ON / OFF
Operation of motor can be heard
VSC / TRC OFF IND
Turns VSC OFF indicator ON / OFF
Operation of motor can be heard
SLIP INDI LIGHT
Turn SLIP indicator light ON / OFF
Operation of motor can be heard
BRAKE WRN LIGHT
Turns BRAKE warning light ON / OFF
Operation of motor can be heard
VSC / BR WARN BUZ
Turns VSC / BRAKE warning buzzer ON / OFF
Buzzer can be heard
H/B MOT RELAY
Turns H/B motor relay ON / OFF
Operation of motor can be heard
STP LIGHT RELAY
Turns stop light relay ON / OFF
Observe stop light