VEHICLE STABILITY CONTROL SYSTEM > CALIBRATION |
| DESCRIPTION |
After replacing the VSC relevant components or performing "Front wheel alignment adjustment", clearing and reading the sensor calibration data are necessary.
Follow the chart to perform calibration.
| Replacing Parts | Necessary Operations |
| Skid Control ECU | Yaw rate sensor and deceleration sensor zero point calibration. |
| Yaw Rate Sensor |
|
| Front Wheel Alignment |
|
| CLEAR ZERO POINT CALIBRATION (for Using a Intelligent Tester) |
![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Operate the intelligent tester to erase the DTCs.

Perform zero point calibration of the yaw rate and deceleration sensor using the intelligent tester.
| PERFORM ZERO POINT CALIBRATION OF YAW RATE SENSOR AND DECELERATION SENSOR (for Using a Intelligent Tester) |
Procedures for test mode.
Turn the ignition switch to OFF.
Check that the steering wheel is in the straight-ahead position.
A/T: Check that the shift lever is in the P position and apply the parking brake.
M/T: Check that the shift lever is in neutral and apply the parking brake.
![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.

Keep the vehicle stationary on a level surface for 2 seconds or more.
![]() |
Check that the VSC TRAC warning light blinks as shown in the illustration.
Turn the ignition switch to OFF.
| CLEAR ZERO POINT CALIBRATION (for Using a Intelligent Tester) |
Turn the ignition switch to the ON position.
![]() |
Using SST, connect and disconnect terminals TS and CG of the DLC3 4 times or more within 8 seconds.
![]() |
Check that the warning light blinks in a normal system indication pattern.
Remove the SST from the terminals of the DLC3.
Perform zero point calibration of the yaw rate and deceleration sensor using a check wire.
| PERFORM ZERO POINT CALIBRATION OF YAW RATE SENSOR AND DECELERATION SENSOR (for Using a SST Check Wire) |
Procedures for test mode:
Turn the ignition switch to OFF.
Check that the steering wheel is in the straight- ahead position.
A/T: Check that the shift lever is in the P position and apply the parking brake. M/T: Check that the shift lever is in neutral and apply the parking brake.
![]() |
Using SST, connect terminals TS and CG of the DLC3.
Turn the ignition switch to the ON position.
Keep the vehicle stationary on a level surface for 2 seconds or more.
![]() |
Check that the VSC TRAC warning light blinks as shown in the illustration.