Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > FREEZE FRAME DATA

for Preparation Click here



HINT:
  1. Whenever a DTC is detected or the ABS operates, the skid control ECU stores the current vehicle (sensor) state as freeze frame data.
  2. The skid control ECU stores the number of times (maximum: 31) the ignition switch has been turned from off to the ON position since the last time ABS was activated. However, if the vehicle was stopped or at low speed (4.3 mph (7 km/h) or less), or if a DTC is detected, the skid control ECU will not count the number after that.
  3. Freeze frame data at the time the ABS operates: The skid control ECU stores and updates the data whenever the ABS system operates. When the ECU stores data at the time a DTC is detected, the data stored when the ABS operated is erased.
  4. Freeze frame data at the time a DTC is detected: When the skid control ECU stores data at the time a DTC is detected, no updates will be performed until the data is cleared.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to the ON position.

  3. Turn the tester ON.

  4. From the display on the tester, select the FREEZE FRAME DATA.


Intelligent Tester
Measurement Item
Reference Value
TROUBLE CODE
Freeze DTC
min.: 0, max.: 65535
STOP LIGHT SW
Stop light switch signal
Stop light switch ON: ON, OFF: OFF
VSC/TRC OFF SW
VSC OFF switch signal
VSC OFF SW ON: ON, OFF: OFF
SHIFT POSITION
Shift lever position
FAIL
P,N
R
D
4
3
2
L
SYSTEM
System status
ABS activated: ABS
VSC/TRAC activated: VSC/TRAC
BA activated: BA
Fail safe mode activated: FAIL SF
No system activated: NO SYS
# IG ON
Number of operations turning ignition switch to ON after strong freeze frame data
0 to 31
VEHICLE SPD
Wheel speed sensor reading
Speed indicated on speedometer
STEERING ANG
Steering sensor reading
Left turn: Increase
Right turn: Drop (Deceleration
YAW RATE
Yaw rate angle sensor reading
-128 to 127
MAS CYL PRESS
Master cylinder pressure sensor reading
Brake pedal release: 0.3 to 0.9 V
Brake pedal depress: 0.8 to 4.5 V
MAS PRESS GRADE
Master cylinder pressure sensor change
-30 to 225 MPa/s
G (RIGHT & LEFT)
Right and left G (Yaw Rate)
-1.869 to 1.869
G (BACK & FORTH)
Back and forth G (Deceleration)
-1.869 to 1.869
WHEEL DIR FR
Front right wheel direction
Wheel direction BACK: BACK
Wheel direction FORWARD: FORWARD
WHEEL DIR FL
Front left wheel direction
Wheel direction BACK: BACK
Wheel direction FORWARD: FORWARD
WHEEL DIR RR
Rear right wheel direction
Wheel direction BACK: BACK
Wheel direction FORWARD: FORWARD
WHEEL DIR RL
Rear left wheel direction
Wheel direction BACK: BACK
Wheel direction FORWARD: FORWARD
BUZZER
VSC buzzer signal
VSC buzzer ON: ON, OFF: OFF
RESERVOIR SW
Reservoir level warning switch signal
Reservoir level warning Switch ON: ON, OFF: OFF
PKB SW
Parking brake switch signal
Parking brake Switch ON: ON, OFF: OFF