Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > Skid Control Buzzer Circuit

for Preparation Click here


DESCRIPTION

The skid control buzzer sounds when the VSV or Hill-start Assist Control (HAC) operates.

WIRING DIAGRAM


C124787E01


INSPECTION PROCEDURE

HINT:
Start the inspection from step 1 when using a intelligent tester and start from step2 when not using a intelligent tester.

1.PERFORM ACTIVE TEST BY INTELLIGENT TESTER (SKID CONTROL BUZZER)
  1. Connect the intelligent tester to the DLC3.

  1. Start the engine.

  1. Select the item "VSC/BR WARN BUZ" in the ACTIVE TEST and operate the skid control buzzer on the intelligent tester.

    Item
    Vehicle Condition / Test Details
    Diagnostic note
    VSV / BR WARN BUZ
    Turns VSV / BRAKE warning buzzer ON /OFF
    Buzzer can be heard

  1. Check that the buzzer sounds/stops when the skid control buzzer is turned on/off by using the intelligent tester.

    Result
    Proceed to
    Buzzer sounds/stops
    A
    Buzzer does not sound or sounds constantly
    B



A
CHECK FOR INTERMITTENT PROBLEMS
B


2.INSPECT SKID CONTROL BUZZER (POWER SOURCE CIRCUIT)


    I044040E01
  1. Disconnect the skid control buzzer connector.

  1. Turn the ignition switch to the ON position.

  1. Measure the voltage.

    Standard:
    Tester Connection
    Specified Condition
    V7-2 - Body ground
    10 to 14 V

  1. Turn the ignition switch to OFF.

  1. Reconnect the skid control buzzer connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)
OK


3.INSPECT SKID CONTROL BUZZER ASSEMBLY


    F002192E08
  1. Disconnect the skid control buzzer connector.

  1. Apply battery voltage to terminals 1 and 2 of the skid control buzzer connector, and check that the buzzer sounds.

    OK:
    The skid control buzzer sound should be heard.

  1. Reconnect the skid control buzzer connector.



NG
REPLACE SKID CONTROL BUZZER ASSEMBLY
OK


4.CHECK HARNESS AND CONNECTOR (SKID CONTROL BUZZER - SKID CONTROL ECU)


    C124803E01
  1. Disconnect the skid control ECU connector.

  1. Disconnect the skid control buzzer connector.

  1. Measure the resistance.

    Standard:
    Tester Connection
    Specified Condition
    S1-30 (BZ) - V7-1
    Below 1 Ω
    S1-30 (BZ) - Body ground
    10 kΩ or higher

  1. Reconnect the skid control buzzer connector.

  1. Reconnect the skid control ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MASTER CYLINDER SOLENOID