VEHICLE STABILITY CONTROL SYSTEM > TS and CG Terminal Circuit |

| 1.INSPECT DLC3 (TS TERMINAL VOLTAGE) |
![]() |
Turn the ignition switch to the ON position.
Measure the voltage.
| Tester Connection | Specified Condition |
| D4-12 (TS) - D4-4 (CG) | 10 to 14 V |
Turn the ignition switch to OFF.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - DLC3) |
![]() |
Disconnect the skid control ECU connector.
Measure the resistance.
| Tester Connection | Specified condition |
| S1-24 (TS) - D4-12 (TS) | Below 1 Ω |
Measure the resistance.
| Tester Connection | Specified Condition |
| S1-24 (TS) - Body ground | 10 kΩ or higher |
Reconnect the skid control ECU connector.
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (BODY GROUND - DLC3) |
![]() |
Measure the resistance.
| Tester Connection | Specified condition |
| D4 (CG) - Body ground | Below 1 Ω |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - DLC3) |
![]() |
Disconnect the skid control ECU connector.
Measure the resistance.
| Tester Connection | Specified condition |
| S1-24 (TS) - D4-12 (TS) | Below 1 Ω |
Measure the resistance.
| Tester Connection | Specified Condition |
| S1-24 (TS) - Body ground | 10 kΩ or higher |
Reconnect the skid control ECU connector.
|
| ||||
| OK | ||
| ||