Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > Slip Indicator Light Remains ON

for Preparation Click here


DESCRIPTION

  1. The SLIP indicator blinks when any of the TRAC, VSV and AUTO LSD operate.
  2. When the system fails, the SLIP indicator light illuminates to warn the driver.

WIRING DIAGRAM


C124786E01


INSPECTION PROCEDURE

HINT:
Start the inspection from step 1 when using a intelligent tester and start from step 2 when not using a intelligent tester.

1.CHECK DTC
  1. Check the DTCs.

    Result
    Proceed to
    DTC not output
    A
    DTC output
    B



B
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS
A


2.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - COMBINATION METER)


    F049577E02
  1. Disconnect the skid control ECU connector.

  1. Disconnect the combination meter connector.

  1. Measure the resistance.

    Standard:
    Tester Connection
    Specified Condition
    S1-34 (IND) - C9-36
    Below 1 Ω

  1. Measure the resistance.

    Standard:
    Tester Connection
    Specified Condition
    S1-34 (IND) - Body ground
    10 kΩ or higher

  1. Reconnect the combination meter connector.

  1. Reconnect the skid control ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT COMBINATION METER ASSEMBLY
  1. Check the combination meter system (Click here).

    OK:
    Combination meter is normal.



NG
REPLACE COMBINATION METER ASSEMBLY
OK

REPLACE MASTER CYLINDER SOLENOID