Home › TRANSMISSION ยท A750F AUTOMATIC TRANSMISSION › AUTOMATIC TRANSMISSION SYSTEM

AUTOMATIC TRANSMISSION SYSTEM > HYDRAULIC TEST

for Preparation Click here



PERFORM HYDRAULIC TEST
G020657E01
  1. Measure the line pressure.

    NOTICE:
    1. Perform the test at the normal operating ATF (Automatic Transmission Fluid) temperature of 50° to 80°C (122° to 176°F).
    2. The line pressure test should always be carried out in pairs. One technician should observe the condition of the wheels or wheel stoppers outside the vehicle while the other is doing the test.
    3. Be careful to prevent the SST hose from interfering with the exhaust pipe.
    4. This check must be conducted after checking and adjusting the engine.
    5. Perform with the A/C OFF.
    6. Do not conduct stall tests for longer than 10 seconds continuously.


    1. Warm up the ATF.

    2. Lift the vehicle up.

    3. Remove the test plug on the transmission case center right side and connect SST.

      SST
      09992-00095   (09992-00151, 09992-00271)

    4. Fully apply the parking brake and chock the 4 wheels.

    5. Start the engine and check the idling speed.

    6. Keep your left foot pressing firmly on the brake pedal and shift into the D position.

    7. Measure the line pressure while the engine is idling.

    8. Depress the accelerator pedal all the way down. Quickly read the highest line pressure when the engine speed reaches the stall speed.

    9. In the same manner, do the test in the R position.

      Specified line pressure:

      Condition
      D position
      R position
      Idling
      363 to 423 kPa
      (3.7 to 4.3 kgf/cm2 , 53 to 61 psi)
      484 to 564 kPa
      (4.9 to 5.8 kgf/cm2, 70 to 82 psi)
      Stall test
      1,282 to 1,381 kPa
      (13.1 to 14.1 kgf/cm2, 186 to 200 psi)
      1,218 to 1,338 kPa
      (12.4 to 13.6 kgf/cm2, 177 to 194 psi)


      Evaluation: 
      Problem
      Possible cause
      Measured value are higher than specified in all positions
      1. Shift solenoid valve SLT defective
      2. Regulator valve defective
      Measured value are lower than specified in all positions
      1. Shift solenoid valve SLT defective
      2. Regulator valve defective
      3. Oil pump defective
      Pressure is low in D position only
      1. D position circuit fluid leakage
      2. No. 1 clutch (C1) defective
      Pressure is low in R position only
      1. R position circuit fluid leakage
      2. No. 3 clutch (C3) defective
      3. No. 4 brake (B4) defective