DTC P0722 Output Speed Sensor Circuit No Signal |

| DTC No. | DTC Detection Conditions | Trouble Areas |
| P0722 |
|
|

| Terminal | SP2+ - SP2- |
| Tool setting | 2 V/DIV, 20 ms/DIV |
| Vehicle condition | Vehicle speed 12 mph (20 km/h) |
| Related DTCs | P0722: Speed sensor SP2/Verify pulse input |
| Required sensors/Components | Speed sensor SP2 |
| Frequency of operation | Continuous |
| Duration | 500 output shaft revolutions |
| MIL operation | Immediate |
| Sequence of operation | None |
| The monitor will run whenever the following DTCs are not present. | P0500: VSS P0748 - P0799: Trans solenoid (range) |
| Vehicle speed sensor pulse input | 4 times |
| Vehicle speed range (4 seconds or more) | 5.59 mph (9 km/h) or more |
| Park/neutral position switch | OFF |
| Battery voltage | 8 V or more |
| Ignition switch | ON |
| Starter | OFF |
| Output speed sensor pulse input | No input |

| Item | Measurement Item/ Range (display) | Normal Condition |
| SPD (SP2) | Counter Gear Speed display/ min.: 0 mph (0 km/h) max.: 158 mph (255 km/h) | Vehicle stopped: 0 mph (0 km/h) [HINT] Equal to vehicle speed |
| 1.INSPECT SPEED SENSOR INSTALLATION |
![]() |
Check the speed sensor (SP2) installation.
|
| ||||
| OK | |
| 2.INSPECT SPEED SENSOR (SP2) |
![]() |
Disconnect the speed sensor (SP2) connector from the transmission.
Measure the resistance.
| Tester Connection | Specified Condition |
| 1 - 2 | 560 to 680 Ω at 20°C (68°F) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (SPEED SENSOR - ECM) |
![]() |
Connect the speed sensor connector.
Disconnect the ECM connector.
Measure the resistance.
| Tester Connection | Specified Condition |
| E5-34 (SP2+) - E5-26 (SP2-) | 560 to 680 Ω at 20°C (68°F) |
Measure the resistance.
| Tester Connection | Specified Condition |
| E5-34 (SP2+) - Body ground | 10 kΩ or higher |
| E5-26 (SP2-) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||