DTC P0778 Pressure Control Solenoid "B" Electrical (Shift Solenoid Valve SL2) |
| DTC No. | DTC Detection Conditions | Trouble Areas |
| P0778 | The ECM checks for an open or short in the shift solenoid valve SL2 circuit (1-trip detection logic):
|
|
| Related DTCs | P0778: Shift solenoid valve SL2/Range check |
| Required sensors/Components | Shift solenoid valve SL2 |
| Frequency of operation | Continuous |
| Duration | 1 second |
| MIL operation | Immediate |
| Sequence of operation | None |
| The monitor will run whenever the following DTCs are not present. | None |
| Battery voltage | 10 V or more |
| CPU requested duty ratio to SL2 | Less than 75 % |
| Ignition switch | ON |
| Starter | OFF |
| Output signal duty | 100 % |
| Output signal duty | Less than 100 % |

| Gearshift controlled by ECM | 1st | 2nd | 3rd | 4th | 5th |
| Shift solenoid valve SL2 | ON | ON | ON | ON | OFF |
| 1.INSPECT TRANSMISSION WIRE (SL2) |
![]() |
Disconnect the transmission wire connector from the transmission.
Measure the resistance.
| Tester Connection | Specified Condition |
| 11 (SL2+) - 3 (SL2-) | 5.0 to 5.6 Ωat 20°C (68°F) |
Measure the resistance.
| Tester Connection | Specified Condition |
| 11 (SL2+) - Body ground | 10 kΩ or higher |
| 3 (SL2-) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (TRANSMISSION WIRE - ECM) |
![]() |
Connect the transmission wire connector to the transmission.
Disconnect the ECM connector.
Measure the resistance.
| Tester Connection | Specified Condition |
| E5-17 (SL2+) - E5-16 (SL2-) | 5.0 to 5.6 Ω at 20°C (68°F) |
Measure the resistance.
| Tester Connection | Specified Condition |
| E5-17 (SL2+) - Body ground | 10 kΩ or higher |
| E5-16 (SL2-) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||
| 3.INSPECT SHIFT SOLENOID VALVE SL2 |
![]() |
Remove the shift solenoid valve SL2.
Measure the resistance.
| Tester Connection | Specified Condition |
| 1 - 2 | 5.0 to 5.6 Ω at 20°C (68°F) |
Connect the positive (+) lead with a 21 W bulb to terminal 2 and the negative (-) lead to terminal 1 of the solenoid valve connector, then check the movement of the valve.
|
| ||||
| OK | ||
| ||