Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > Downhill Assist Control Indicator Light does not Come ON

for Preparation Click here


WIRING DIAGRAM

Click here.

INSPECTION PROCEDURE

1.CHECK DOWNHILL ASSIST CONTROL INDICATOR LIGHTy


    C121700E24
  1. Disconnect the skid control ECU connector.

  1. Turn the ignition switch to the ON position.

  1. Ground terminal HDCW of the skid control ECU.

  1. Check DAC indicator light.

    OK:
    HDCW - GND Condition
    Illumination Condition
    Connecting
    OFF
    Disconnecting
    ON

  1. Turn the ignition switch to OFF.

  1. Reconnect the skid control ECU connector.



NG
Go to step 3
OK


2.INSPECT DOWNHILL ASSIST CONTROL SWITCH


    I044044E02
  1. Remove the DAC switch.

  1. Disconnect the DAC switch connector.

  1. Measure the resistance.

    Standard:
    Tester Connection
    Switch Condition
    Specified Condition
    D8-3 - D8-4
    Released
    10 kΩ or higher
    D8-3 - D8-4
    Pushed in
    Below 1 Ω

  1. Reconnect the DAC switch connector.

  1. Reinstall the DAC switch connector.



NG
REPLACE DOWNHILL ASSIST CONTROL SWITCH
OK


3.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - DAC SWITCH)


    F052063E02
  1. Disconnect the skid control ECU connector.

  1. Disconnect the DAC switch connector.

  1. Measure the resistance.

    Standard:
    Tester Connection
    Specified Condition
    S1-44 (HDCS) - D8-3
    Below 1 Ω
    S1-44 (HDCS) - Body ground
    10 kΩ or higher
    D8-4 - Body ground
    Below 1 Ω

  1. Reconnect the DAC switch connector.

  1. Reconnect the skid control ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MASTER CYLINDER SOLENOID 

4.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - COMBINATION METER)


    F049387E07
  1. Disconnect the skid control ECU connector.

  1. Disconnect the combination meter connector.

  1. Measure the resistance.

    Standard:
    Tester Connection
    Specified Condition
    S1-33 (HDCW) - C10-13
    Below 1 Ω
    S1-33 (HDCW) - Body ground
    10 kΩ or higher

  1. Reconnect the combination meter connector.

  1. Reconnect the skid control ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.INSPECT COMBINATION METER ASSEMBLY
  1. Check the combination meter system (Click here).

    OK:
    Combination meter is normal.



NG
REPLACE COMBINATION METER ASSEMBLY
OK

CHECK FOR INTERMITTENT PROBLEMS