Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > AUTO LSD Indicator Light Remains ON

for Preparation Click here


DESCRIPTION

This is the AUTO LSD main switch. When the AUTO LSD switch is pushed on, the AUTO LSD function is available and the AUTO LSD indicator light illuminates.

HINT:
The AUTO LSD does not operate even if the AUTO LSD switch is pressed under the following conditions:
  1. TRAC or VSV system is faulty.
  2. Temperature inside the hydraulic brake booster increases and the AUTO LSD operation is suspended.


WIRING DIAGRAM


C124785E02


INSPECTION PROCEDURE

1.CHECK SKID CONTROL ECU CONNECTOR
  1. Check the ECU Connector's connecting condition.

    OK:
    The connector is securely connected.



NG
CONNECT CONNECTOR CORRECTLY
OK


2.INSPECT BATTERY
  1. Check the battery voltage.

    Standard:
    11 to 14 V



NG
INSPECT CHARGING SYSTEM
OK


3.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - COMBINATION METER)


    F049577E01
  1. Disconnect the skid control ECU connector.

  1. Disconnect the combination meter connector.

  1. Measure the resistance.

    Standard:
    Tester Connection
    Specified Condition
    S1-15 (INFR) - C9-35
    Below 1 Ω
    S1-15 (INFR) - Body ground
    10 kΩ or higher

  1. Reconnect the combination meter connector.

  1. Reconnect the skid control ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.INSPECT COMBINATION METER ASSEMBLY
  1. Check the combination meter system (Click here).

    OK:
    Combination meter is normal.



NG
REPLACE COMBINATION METER ASSEMBLY
OK


5.INSPECT SKID CONTROL ECU (CSW TERMINAL)


    C121700E26
  1. Disconnect the skid control ECU connector.

  1. Ground terminal CSW of the skid control ECU.

    Standard:
    Tester Connection
    Condition
    Specified Condition
    S1-43 (CSW) - Body ground
    AUTO LSD switch not pushed in
    10 kΩ or higher

  1. Reconnect the skid control ECU connector.



OK
REPLACE MASTER CYLINDER SOLENOID
NG


6.INSPECT AUTO LSD SWITCH


    I044044E01
  1. Remove the AUTO LSD switch.

  1. Disconnect the AUTO LSD switch connector.

  1. Measure the resistance.

    Standard:
    Tester Connection
    Switch Condition
    Specified Condition
    T9-3 - T9-4
    Released
    10 kΩ or higher
    T9-3 - T9-4
    Released
    Below 1 Ω

  1. Reconnect the AUTO LSD switch connector.

  1. Reinstall the AUTO LSD switch.



NG
REPLACE AUTO LSD SWITCH
OK


7.CHECK HARNESS AND CONNECTOR (AUTO LSD SWITCH CIRCUIT)


    C124802E01
  1. Disconnect the skid control ECU connector.

  1. Disconnect the AUTO LSD connector.

  1. Measure the resistance.

    Standard:
    Tester Connection
    Specified Condition
    S1-43 (CSW) - T9-3
    Below 1 Ω
    S1-43 (CSW) - Body ground
    10 kΩ or higher
    T9-3 - Body ground
    Below 1 Ω

  1. Reconnect the AUTO LSD connector.

  1. Reconnect the skid control ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MASTER CYLINDER SOLENOID