Home › TRANSMISSION · CLUTCH › CLUTCH START CANCEL SWITCH

CLUTCH START CANCEL SWITCH > INSPECTION

for Preparation Click here



1. INSPECT CLUTCH START CANCEL SWITCH ASSEMBLY


F051593E01
  1. Using an ohmmeter, check that there is resistance between terminals 2 and 4.

    Standard:
    10 kΩor higher

    If the result is not as specified, replace the clutch start cancel switch.



    F051594E01
  1. Connect the positive (+) lead from the battery to terminal 3 and connect negative (-) lead to terminal 1.

  1. Using an ohmmeter, check that there is resistance between terminals 2 and 4.

    Standard:
    10 kΩor higher

    If the result is not as specified, replace the clutch start cancel switch.



    F051595E01
  1. Check that the indicator light comes on and there is resistance between terminals 2 and 4 when the switch is pressed.

    Standard:
    Blow 1 Ω

    If the result is not as specified, replace the clutch start cancel switch.



    F051596E01
  1. Using an ohmmeter, check that there is resistance between terminals 2 and 4 when the battery lead is disconnected.

    Standard:
    10 kΩor higher

    If the result is not as specified, replace the clutch start cancel switch.