POWER WINDOW CONTROL SYSTEM > Rear Power Window LH does not Operate with Rear Power Window Switch LH |

| 1.CHECK REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (B VOLTAGE) |
![]() |
Disconnect the P15 power window regulator switch connector.
Turn the ignition switch ON.
Measure the voltage.
| Tester Connection | Condition | Specified Condition |
| P15-3 (B) - Body ground | Ignition switch ON | 10 to 14 V |
Reconnect the power window regulator switch connector.
|
| ||||
| OK | |
| 2.INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY (REAR LH) (SWITCH OPERATION) |
![]() |
Remove the power window regulator switch.
Disconnect the P15 power window regulator switch connector.
Measure the resistance between the terminals of the connector when the switch is operated.
| Tester Connection | Regulator Switch | Specified Condition |
| P15-5 (D) - P15-4 (SD) P15-1 (U) - P15-3 (B) | UP | Below 1 Ω |
| P15-5 (D) - P15-4 (SD) P15-1 (U) - P15-2 (SU) | OFF | Below 1 Ω |
| P15-5 (D) - P15-3 (B) P15-1 (U) - P15-2 (SU) | DOWN | Below 1 Ω |
Reconnect the power window regulator switch connector.
Reinstall the power window regulator switch.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (REGULATOR SWITCH - REGULATOR MOTOR AND BODY GROUND) |
![]() |
Disconnect the P15 power window regulator switch connector.
Disconnect the P12 power window regulator motor connector.
Measure the resistance.
| Tester Connection | Specified Condition |
| P15-5 (D) - P12-1 | Below 1 Ω |
| P15-1 (U) - P12-2 | Below 1 Ω |
| P15-5 (D) - Body ground | 10 kΩ or higher |
| P15-1 (U) - Body ground | 10 kΩ or higher |
Reconnect the power window regulator switch connector.
Reconnect the power window regulator motor connector.
|
| ||||
| OK | |
| 4.INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (REAR LH) |
![]() |
Remove the power window regulator motor.
Apply battery voltage to connector terminals 1 and 2.
Check that the motor smoothly rotates.
| Terminal No. | Specified Condition |
| Battery positive (+) → 2 Battery negative (-) → 1 | Motor gear rotates clockwise |
| Battery positive (+) → 1 Battery negative (-) → 2 | Motor gear rotates counterclockwise |
Reinstall the power window regulator motor.
|
| ||||
| OK | ||
| ||