Home › BODY › EXTERIOR › WHEEL OPENING MOULDING

WHEEL OPENING MOULDING > REMOVAL

for Preparation Click here



1. REMOVE FRONT FENDER MUDGUARD (for 4WD and Pre-Runner)


    B087507E01
  1. Using a clip remover, remove the 3 clips.

  1. Remove the 3 screws and front fender mudguard.



2. REMOVE ROCKER PANEL MOULDING (for X-Runner)


    B087655E01
  1. Remove the 4 screws.



    B087656E02
  1. Apply protective tape to the outer circumference of the rocker panel moulding, as shown in the illustration.

  1. Using a moulding remover, disengage the 9 clips and remove the rocker panel moulding.



    B088257E02
  1. Turn the clips 90° clockwise and remove them.



3. REMOVE FRONT FENDER WHEEL OPENING MOULDING


    B087679E01
  1. for 4WD and Pre Runner:

    1. Remove the 4 screws.



    2. B087680E01
    3. Apply protective tape to the outer circumference of the front fender wheel opening moulding, as shown in the illustration.

    4. Using a moulding remover, disengage the 9 clips and remove the front fender wheel opening moulding.



    5. B088257E03
    6. Turn the clips 90° clockwise and remove them.



    B087651E01
  1. for X-Runner:

    1. Remove the 5 screws and front fender wheel opening moulding.



4. REMOVE REAR QUARTER PANEL MUDGUARD (for 4WD and Pre-Runner)


    B087509E01
  1. for 2WD:

    1. Remove the 3 screws and rear quarter panel mudguard.



    B087508E01
  1. for 4WD and Pre Runner:

    1. Using a clip remover, remove the 3 clips.

    2. Remove the 3 screws and rear quarter panel mudguard.



5. REMOVE BACK DOOR OUTSIDE MOULDING SUB-ASSEMBLY (for X-Runner)


    B087665E01
  1. Remove the 3 screws.



    B087666E01
  1. Apply protective tape to the outer circumference of the back door outside moulding, as shown in the illustration.

  1. Using a moulding remover, disengage the 3 clips and remove the back door outside moulding.



    B088257E02
  1. Turn the clips 90° clockwise and remove them.



6. REMOVE BODY ROCKER PANEL MOULDING ASSEMBLY (for X-Runner)


    B087660E01
  1. Remove the 3 screws.



    B087661E01
  1. Apply protective tape to the outer circumference of the body rocker panel moulding, as shown in the illustration.

  1. Using a moulding remover, disengage the 3 clips and remove the body rocker panel moulding.



    B088257E02
  1. Turn the 90° clockwise and remove them.



7. REMOVE QUARTER PANEL WHEEL OPENING MOULDING


    B087684E01
  1. for 4WD and Pre Runner:

    1. Remove the 5 screws.



    2. B087685E01
    3. Apply protective tape to the outer circumference of the quarter panel wheel opening moulding, as shown in the illustration.

    4. Using a moulding remover, disengage the 10 clips and remove the quarter panel wheel opening moulding.



    5. B088257E03
    6. Turn the clips 90° clockwise and remove them.



    B087653E01
  1. for X-Runner:

    1. Remove the 5 screws and quarter panel wheel opening moulding.