Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING VALVE AND TRANSMITTER

TIRE PRESSURE WARNING VALVE AND TRANSMITTER > REMOVAL

for Preparation Click here



1. REMOVE FRONT TIRE


2. REMOVE REAR TIRE


3. REMOVE SPARE TIRE


4. REMOVE TIRE PRESSURE WARNING VALVE AND TRANSMITTER
  1. Remove the valve core and the cap, and release air from the tire.

  1. After ensuring that air is sufficiently released, remove the nut and washer that are used to fix the tire pressure warning valve and transmitter and drop the valve sensor inside the tire.

    HINT:
    Keep the removed cap, valve core, nut and washer.



    C083779E01
  1. After dropping the tire pressure warning valve and transmitter into the tire, disengage the bead using the shoe of the tire remover.

    NOTICE:
    Do not damage the tire pressure warning valve and transmitter because of interference between the sensor and tire bead.

  1. Remove the bead on the upper side.

  1. Take the valve sensor out of the tire and remove the bead on the valve.

    HINT:
    Check that there are no cracks or damage to the grommet. If any damage is found, replace the grommet together with the washer and nut.