SFI SYSTEM > DTC CHECK / CLEAR |
| Pending DTC | Store condition | Malfunction detected |
| Clear condition | System determined to be normal or DTCs cleared using Techstream or Cable disconnected from negative battery terminal | |
| Current DTC | Store condition | Malfunction detected (2nd trip) |
| Clear condition | No malfunctions in 40 driving cycles or DTCs cleared using Techstream or Cable disconnected from negative battery terminal | |
| Permanent DTC | Store condition | Malfunction detected (2nd trip) |
| Clear condition | Ignition switch turned to ON after normal judgment obtained in 3 consecutive driving cycles or After DTCs cleared using Techstream or cable disconnected from negative battery terminal, normal judgment obtained and universal trip performed (not for misfire and fuel system DTCs) or After DTCs cleared using Techstream or cable disconnected from negative battery terminal, malfunction not detected when universal trip driving pattern performed (misfire and fuel system DTCs) | |
| MIL | ON | Malfunction detected (2nd trip) |
| OFF | Ignition switch turned to ON after normal judgment obtained in 3 consecutive driving cycles or DTCs cleared using Techstream or Cable disconnected from negative battery terminal |


| CHECK DTC (Using the Techstream) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Check DTCs and freeze frame data, and then write them down.
Proceed to Diagnosis Trouble Code Chart to check the details of the DTCs (Click here).
| CLEAR DTC (Using the Techstream) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Press the YES button.
| CLEAR DTC (Without using the Techstream) |
Perform either one of the following operations.
Disconnect the cable from the negative battery terminal for more than 1 minute.
Remove the EFI and ETCS fuses from the Relay Block (R/B) located inside the engine compartment for more than 1 minute.
| CLEAR PERMANENT DTC |

Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Check if permanent DTCs are stored.
Clear DTCs.
Perform the respective confirmation driving patterns in order to obtain a normal judgment for the output DTCs.
Perform the universal trip.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Check that the permanent DTCs have been cleared.