SFI SYSTEM > CHECK MODE PROCEDURE |
| CHECK MODE PROCEDURE (Using the Techstream) |
Check and ensure the following conditions:
Battery voltage 11 V or more
Throttle valve fully closed
Shift lever is P or N (Neutral)
A/C switched off
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Utility / Check Mode.
Switch the ECM from normal mode to check mode.
![]() |
Make sure the MIL flashes as shown in the illustration.
Start the engine.
Make sure the MIL turns off.
Simulate the conditions of the malfunction described by the customer.
Check DTCs and freeze frame data using the Techstream.