Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch ON.

  3. Turn the Techstream on.

  4. Enter the following menus:
    Powertrain / Cruise Control / Data List.

  5. According to the display on the Techstream, read the Data List.

    Cruise Control 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    CCS Vehicle Spd
    Vehicle speed/min.: 0 km/h (0 mph), max.: 255 km/h (158 mph)
    Actual vehicle speed
    -
    CCS Mem Vehicle Spd
    Cruise control memorized speed/min.: 0 km/h (0 mph), max.: 255 km/h (158 mph)
    Actual stored vehicle speed
    -
    Cruise Control
    Cruise control system active condition/ON or OFF
    ON: Cruise control activated
    OFF: Cruise control deactivated
    -
    CCS Main SW M-CPU
    Main switch signal (Main CPU)/ON or OFF
    ON: Main switch on (Pushed on)
    OFF: Main switch off (Pushed off)
    "3"
    CCS Ready M-CPU
    Cruise control system standby condition (Main CPU)/ON or OFF
    ON/OFF: Change ON/OFF each time Main SW is pushed in.
    "1"
    CCS Indicator M-CPU
    Cruise indicator signal (Main CPU)/ON or OFF
    ON: "CCS READY" ON
    OFF: "CCS READY" OFF
    "2"
    Cancel Switch
    CANCEL switch signal/ON or OFF
    ON: CANCEL switch on
    OFF: CANCEL switch off
    -
    SET/COAST Switch
    -/SET switch signal/ON or OFF
    ON: -/SET switch on
    OFF: -/SET switch off
    -
    RES/ACC Switch
    +/RES switch signal/ON or OFF
    ON: +/RES switch on
    OFF: +/RES switch off
    -
    Stop Light SW M-CPU
    Stop light switch signal (Main CPU)/ON or OFF
    ON: Brake pedal depressed
    OFF: Brake pedal released
    -
    Cruise Operation Status
    PNP switch signal (D position)/ON or OFF
    ON: Shift lever in D
    OFF: Shift lever not in D
    -
    CCS Request Torque
    Cruise control request torque/min.: -1024 Nm, max.: 1016 Nm
    Actual required torque
    -
    # Codes
    Number of present trouble codes/min.: 0, max.: 255
    Number of DTCs will be displayed
    -

    HINT:
    1. "3" is OK but "1" is NG → ECM failure
    2. "1" is OK but "2" is NG → DTC output or ECM failure
    3. "3" is OK but CRUISE indicator does not come on → CRUISE main indicator, wire harness or ECM failure